Warehouse roof tile installation method

The advantages of steel structure are light weight, fast factory manufacturing and installation, fast return on investment, and less environmental pollution. It has the impact of protecting the environment in a more environmentally friendly manner compared to traditional structures. Therefore, steel structures have been widely promoted and used all over the world, especially in industrialized countries and regions.

In the project, the roofing materials used in most steel structure workshops are color steel tiles. In addition, color steel tiles are often used in the walls and roofs of large public buildings, prefabricated houses, and comprehensive houses because of their advantages such as convenient construction, fast cycle, low overall cost, bending resistance, corrosion resistance, and elegant appearance. In this article, we will share with you the Warehouse roof tile installation method

How to Warehouse roof tile installation ?

The first step: start from the side of the gable wall, laying from left to right (or from right to left). After the first board is installed, press down to check whether it is fastened. Then pull the alignment along the lower edge of the board, install each piece according to the alignment, and check for deviation at any time.

Step 2: Install color steel tiles at the top and fix them with self-tapping screws. The spacing is 50CM~100CM horizontally and vertically, but it should be installed according to the requirements of corrugated spacing.

Step 3: The first fixing seat in the first row is fixed on the leftmost side of the purlin with self-tapping screws, and a plastic waterproof gasket is attached, and the hole is waterproofed with glass glue during installation. Then make a reference line on the elastic ink line of the purlin, and then fix the fixing seat in the same row.

Step 4: Fix the short arm of the fixing seat on the mother rib of the first paving slab, construct according to the above method, and adjust to the level.

Step 5: Lay according to the above sequence, and finally install the eave cover directly on the lower end of the tile, that is, at the eaves, and fix it with screws. At the junction of the tile ridges, trim the control interface with scissors, and then lap and seal it with glass glue.

Safety Precautions:

1.Construction personnel must wear safety helmets, overalls, seat belts and non-slip flat shoes. Construction workers who are unwell are not allowed to work on the roof.

2.The roof slope is relatively large. In the process of grass-roots treatment and hanging tiles, workers must be strictly informed of safety techniques and safety protection measures.

3.The skeleton must be installed firmly. Pay attention to construction safety when erecting and dismantling the scaffolding to ensure normal construction.

4.Do not walk on the color steel tile unless necessary. When it is necessary to walk on the color steel tiles, protective measures should be taken in advance, try to step on the middle of the color steel tiles, and do not walk along the edge of the color steel tiles. There may be a risk of edge breakage.

5.When Warehouse roof tile installation , in case of bad weather, please do not construct to avoid accidents. Safety guardrails, safety nets or other protective measures against falling must be set up around the roof and in the reserved holes to ensure construction safety.

After the roof color steel tile is installed, it is necessary to protect the finished product of the color steel tile to ensure the quality and smooth completion of the color steel tile. At the same time, the installers of color steel tiles also need to do safety work in strict accordance with the construction requirements. This is as much a responsibility to the project as it is to yourself and others. The above are some methods about the installation of color steel tile roofs, I hope it will be helpful to you.